GacoFlex N-1207

GacoFlex N-1207 is a one-component, VOC-compliant, general purpose adhesive based on neoprene that complies with San Diego Air Pollution Control District Rule 67.21 and California Air Quality Standards.

USAGE

Contact adhesive for bonding rubber, neoprene, leather and other materials to themselves or to concrete, wood, steel or other metals.

COLOR

Amber Brown

APPLIED PRODUCT DATA

COVERAGE:

Sq. Ft./Gal./Mil., 286 (48 m² / L / .025 mm)

SOLIDS

• Weight: Method 4041, Fed. Std. 141, 17% ± 0.5%
• Volume: 17.8% ± 0.5%

V.O.C.

Volatile organic compounds content is 243 grams per liter.

PACKAGED PRODUCT DATA

WEIGHT PER GALLON:

10.65 Lbs. (4.8 kg) ± 0.5%

FLASH POINT

• ASTM D-56
• 45°F (7.22°C) T.C.C.

STORAGE STABILITY

Twelve (12) Months

THINNER

Not recommended

APPLICATION

Surfaces must be clean and dry, free from all oil, grease and corrosion products. Refer to primer recommendations for Gaco Western elastomers. Stir adhesive thoroughly before using. Apply 1-2 coats of GacoFlex N-1207 to both surfaces by brush. Apply sufficient N-1207 to assure uniform coverage over entire area, between 150-200 square feet per gallon (4.1 L / 15 to 20 m²) per coat.

Allow adhesive to dry to touch. Normally a drying time of 1 to 1½ hours is sufficient. It is important to allow complete drying of N-1207 adhesive. Poor adhesion can result from mating the two surfaces before N-1207 is sufficiently dry; note that even after drying overnight, N-1207 can be reactivated by a light solvent wiping with Gaco thinner.

GacoFlex N-1207 provides a good, firm bond upon contact and care should be exercised to align surfaces properly. After contact, press surfaces together using manual or mechanical means of applying pressure.

An instantaneous bond is achieved which increases in strength for several weeks as the adhesive cures. The initial bond is strong enough for immediate service in most instances.